Manual page
several printer languages are being used.
PostScript errors occur, open the Print Options window and click
the desired selection next to the PostScript errors section.
cannot be
printed.
driver may not be
installed correctly.
Software section.
version is available for
printing.
representative.
Error” message
appears.
too complex.
the complexity of the page or
install more memory.
error page
prints.
not be PostScript.
is a PostScript job. Check to
see whether the software
application expected a setup
or PostScript header file to
be sent to the machine.
tray is not
selected in the
driver.
has not been
configured to
recognize the
optional tray.
properties, select the Device
Settings tab, and set the
Tray option of the Installable
Options section to Installed.
a document in
Macintosh with
Acrobat
Reader 6.0 or
higher, colors
incorrectly.
setting in the
printer driver may
not be matched
with the one in
Acrobat Reader.
setting in your printer driver
matches the one in Acrobat
Reader.
print.
System) version distributed with SuSE
Linux 9.2 (cups-1.1.21) has a problem with
ipp (Internet Printing Protocol) printing.
print.
configuration tool and switch to the
Printers tab in the Printers configuration
window to look at the list of available
printers. Make sure that your machine is
displayed on the list. If not, use the Add
new printer wizard to set up your device.
machine on the printers list. Look at the
description in the Selected printer pane.
If its status contains “(stopped)” string,
please, press the Start button. After that,
normal operation of the printer should be
restored. The “stopped” status might be
activated when some problems in
printing occurred. For instance, this
could be an attempt to print documents
when the port is claimed by a scanning
application.
and scanner) share the same I/O
interface (port), the situation of
simultaneous access for different
“consumer” application to the same port
is possible. To avoid possible conflicts,
only one of them is allowed to gain
control over the device at a time. The
other “consumer” will encounter “device
busy” response. You should open the
ports configuration and select the port
assigned to your printer. In the Selected
port pane you can see if the port is
occupied by some other application. If
this is the case, you should wait for
completion of the current job or you
should press the Release port button, if
you are sure that the owner is not
functioning properly.
is specified in the command line
parameter then remove it to print
properly. For Gimp front-end, select
“print” -> “Setup printer” and edit the
command line parameter in the
command item.