Manual page
connected to the DVI OUT jack.
displays for some programs.
POWER button doesn’t work.
program.
does not match with the TV in the
RGB/DVI mode.
work after setting up the remote
control type.
compatible, you may not be able to view video from
your DIRECTV
video output jack on the DIRECTV
closed caption displays.
To avoid this problem, turn on closed captions on either
the TV or the DIRECTV
back in and turn it on.
Check the batteries in the remote control.
want to watch.
Call your service provider if you are not sure.
Make sure your system is not locked by looking for the
locked icon (
Try purchasing another showing of the same program.
Make sure the telephone line is properly connected.
If your system is locked, make sure the purchase does
not exceed your spending or rating limit.
Your Access Card may be full.
Call your service provider for assistance.
provider for assistance.
function because different TV vendor uses a different
screen offset.
Use the “Monitor Setup” menu in the installation menu.
The default setting is “Samsung Electronics DLP
products”.
and set the remote control type as IR & RF.
See the page 102 for more details on setting the remote
control type.
the POWER light does not light.
program image is cut off.
“(Due to) Copyright restrictions......”
sure it it turned on. If your DIRECTV
and turned on. Check the batteries in the remote
control.
Make sure the A/V cables are properly connected.
DIRECTV
Check the signal strength from the satellite (see
Checking the satellite signal strength in Chapter 3).
Make sure the coaxial cable is properly connected to
the satellite dish. Check the connections between your
DIRECTV
in, and turn it on.
out jacks (Video Out, S-Video Out, or TV out), and you
view a high-definition program with the DIRECTV
1080i, the picture will be slightly cropped at the top
and bottom (the very top and bottom edges of the
image will not appear on the TV screen). To avoid this
problem, set the RESOLUTION button to the 480p/i
position if your TV is connected to one of the composite
video outputs.
may not be viewed on some outputs. Use a different
connection from the DIRECTV