Manual page
page is
blank.
too complex.
any unnecessary graphics from the
document.
Install more memory in your printer.
See “Installing Memory DIMM” on
page 9.1.
setting may be
incorrect.
application. For details, see the
Software Section.
the paper size
settings do not
match.
printer driver settings matches the
paper in the tray.
Or, ensure that the paper size in the
printer driver settings matches the
paper selection in the software
application settings you use.
keeps
jamming.
paper in the paper
tray.
If printing on special materials, use
the Multi-Purpose Tray.
paper is being used.
specifications.
If printing on special materials, use
the Multi-Purpose Tray.
method is being
used.
paper, should not be printed using
the output tray (face-down). Use the
rear cover (face-up) instead.
inside the machine.
debris.
prints, but
the text is
wrong,
garbled, or
incomplete.
loose or defective.
cable. Try a print job that you have
already printed successfully. If
possible, attach the cable and
printer to another computer and try
a print job that you know works.
Finally, try a new printer cable.
driver was selected.
selection menu to ensure that your
printer is selected.
application is
malfunctioning.
application.
prints, but
the text is
wrong,
garbled, or
incomplete.
system is
malfunctioning.
version), exit to a DOS prompt and
verify functionality with the following
command: At a C:\ prompt, type
Dir LPT1, and press Enter. (This
assumes you are connected to
LPT1.)
Exit Windows and reboot the
computer. Turn the printer off and
then back on again.
job before turnning
the printer on.
printer and start your job.
but are
blank.
is defective or out of
toner.
page 6.2.
If necessary, replace the toner
cartridge. See page 6.3.
blank pages.
not contain blank pages.
the controller or the
board, may be
defective.
illustrations
incorrectly in
Adobe
Illustrator.
software application
is wrong.
the Advanced Options window of
the graphic properties. Print the
document again.