2
.6
<System setup>
Network menu
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
Item
Explanation
TCP/IP
This item allows you to manually set the TCP/IP
addresses or receive the addresses from the
network.
•
DHCP
: The DHCP server allots the IP address to
you automatically.
•
BOOTP
: The BOOTP server allots the IP address
to you automatically.
•
Static
: You can enter IP address, subnet mask,
and gateway manually.
EtherTalk
This item lets you select whether or not you use the
EtherTalk protocol. Select
On
to use the protocol.
NetWare
This item lets you select the IPX frame type.
•
Auto
: You can set the frame type automatically.
•
802.2
: Select this value to use the IEEE 802.2
frame type.
•
802.3
: Select this value to use the IEEE 802.3
frame type.
•
Ethernet II
: Select this value to use the Ethernet 2
frame type.
•
SNAP
: Select this value to use the SNAP frame
type.
•
Off
: You can disable the NetWare protocol.
Ethernet
Speed
This item allows you to select the ethernet speed.
Wireless
Note
This menu only appears when an optional
wireless network interface card has been
installed.
Values: DHCP, BOOTP, Static
Values:
Off
,
On
Values: Auto, 802.2, 802.3, Ethernet II, SNAP, Off
Values: Auto, 10M Half, 10M Full,
100M Half, 100M Full
Values: WLAN Basic, WLAN Security, WLAN Default
Printing a demo page
Print a demo page to make sure that the printer is operating correctly.
ML-3050, ML-3051N
Press and hold
Demo
for about 2 seconds.
ML-3051N, ML-3051ND
1
Press
Menu
and then
OK
when
Information
appears.
2
Press the
Scroll
buttons until
Demo Page
appears and press
OK
.
A demo page prints out.
Changing the display language
(
ML-3051N
,
ML-
3051ND
only)
To change the language that is displayed on the control panel, follow
these steps:
1
Press
Menu
until
System Setup
appears on the bottom line of the
display and press
OK
.
2
Press
OK
when
Language
appears.
3
Press the
Scroll
buttons to select the language you want and press
OK
.
4
Press
Stop
to return to Standby mode.
Clear
Setting
This item performs a simple reset and restores the
factory default settings for the network
configuration. This setting will only take effect after
you have reset the printer.
Network
Info
This item print a page showing the network
parameters you set.
Item
Explanation