Manual page
S
ETTING
U
P
Y
OUR
P
RINTER
2.8
To print from computer software, you need to connect your printer to your
computer with a parallel interface cable.
The parallel cable should be compatible with the Centronics
R
parallel interface
and IEEE standard 1284. If you purchase a parallel cable, ensure that it :
•
Is compatible with Centronics interface.
•
Supports bi-directional communications(IEEE standard 1284).
•
Is shielded.
•
Has the appropriate connector :
- 25 pin D-Sub connector on the computer side.
- Amphenol 36 connector on the printer side.
Connecting the Parallel Cable
Cable Specifications (Not provided)
Connecting the Parallel Cable
2
Plug the appropriate end of the
parallel cable into the connector on
the rear of the printer.
To connect the printer to your computer use a parallel cable and
proceed as follows.
1
Check that both the printer and the computer to which it is to be connected
are powered off and disconnected from the power point.