Manual page
• Use this setting only if Auto Setup detected the
With the DVD in Stop or Play mode, press the
MENU button.
Using the UP/DOWN buttons, move the selection
bar to “SETUP” then press ENTER to select.
Using the UP/DOWN buttons, move the selection
bar to “Channel”, then press ENTER to select.
Move the selection arrow to “Ant./Cable” then press
RIGHT button to select from the following options:
• Antenna - Indicates that the DVD-VCR is
connected to an indoor or outdoor VHF/UHF
antenna.
• Cable TV - Indicates that the DVD-VCR is
Auto Power Off : Off
Auto Channel Memory
Antenna
With the DVD in Stop or Play mode, press the
MENU button.
Using the UP/DOWN buttons, move the selection
bar to “Setup” then press ENTER to select.
Using the UP/DOWN buttons, move the selection
bar to “Channel,” then press ENTER to select.
Move the selection bar to “RF Output CH”, then
press right to change.
A message will appear on your TV.
Then press ENTER to change.
A message will appear on your TV. When the
message disappears, change your TV to channel 3
or 4 to match the RF output channel of the player.
Auto Power Off : Off
Auto Channel Memory
4CH