Manual page
U
SING
P
RINT
M
ATERIALS
4.23
4
1
Open the Multi-Purpose Tray and the rear output tray.
2
Load print material with print side up and short edge first.
Adjust the guide to fit the width of the material stack.
3
When you print, configure the paper source, type and size
properly in the software application. For details, see
page 5.7.
N
OTE
: If the size of your print material is not listed in the Size
box in the
Paper tab of the printer driver properties, click the
C
AUTIONS
: When you use
76 by 127 mm
(3 by 5 in. )paper and it
is too thin, a paper jam may occur. Use the card stock heavier than
105g/m
2
For details about setting on the control panel, see page
page 3.5.
4
After printing, close the Multi-Purpose Tray and the rear
output tray.