Manual page
message appears
during installation.
software from the StartUp Group, then restart
Windows. Reinstall the printer driver.
LPTx” message
appears.
message.
Protection Fault”,
“Exception OE”,
“Spool32”, or
“Illegal Operation”
messages appear.
and try printing again.
printer timeout
error occurred.”
messages appear.
Just keep waiting until the machine finishes
printing. If the message appears in standby
mode or after printing has been completed,
check the connection and/or whether an error
has occurred.
not print PDF file
correctly. Some
parts of graphics,
text, or illustrations
are missing.
Acrobat products:
Printing the PDF file as an image may solve
this problem. Turn on Print As Image from the
Acrobat printing options.
N
messages.
print.
configurator and switch to the Printers
tab in Printers configuration window to
look at the list of available printers.
Make sure that your machine is
displayed on the list. If not, please,
invoke Add new printer wizard to set up
your device.
machine on the printers list. Look at the
description in the Selected printer pane.
If its status contains “(stopped)” string,
please, press the Start button. After that
normal operation of the printer should
be restored. The “stopped” status might
be activated when some problems in
printing occurred. For instance, this
could be an attempt to print document
when port is claimed by a scanning
application.
and scanner) share the same I/O
interface (port), the situation of
simultaneous access of different
“consumer” application to the same port
is possible. To avoid possible conflicts,
only one of them at a time is allowed to
gain control over the device. The other
“consumer” will encounter “device busy”
response. You should open ports
configuration and select the port
assigned to your printer. In the Selected
port pane you can see if the port is
occupied by some other application. If
this is the case, you should wait for
completion of the current job or should
press Release port button, if you are
sure that the present owner is not
functioning properly.
specified in the command line
parameter then remove it to print
properly. For Gimp front-end, select
“print” -> “Setup printer” and edit
command line parameter in the
command item.