Manual page
13.8
<Maintenance>
7
Holding the handles on the new imaging unit, push the imaging unit
until it sounds ‘click’ into the machine.
8
Remove four dummy caps which are on the toner cartridge
entrances of the imaging unit. When you remove the dummy cap
from the cartridge, lift the handle up and pull it out.
Caution
• If you force too much to the dummy caps, it may cause
problem.
9
Insert the toner cartridges and waste toner container into their
corresponding slots until they click into place.
10 Close the front cover firmly.
11 Turn the machine on.
Caution
• If the front cover is not completely closed, the machine will not
operate.
Note
• After rebooting, your machine will automatically reset the
counter for the imaging unit.
• If the installation is completed properly, a guide report is
printed out automatically. Wait for about 1.5 minutes for the
machine to get ready.
Caution
• If there is a cracking sound, re-install the imaging unit. The
imaging unit is not properly installed.