Manual page
necessary in order to use
the various timer features
of the TV. Also, you can
check the time while
watching the TV. (Just
press the INFO button.)
180 minutes after which the TV automatically
switches to standby mode.
control repeatedly until the appropriate time
interval appears (any of the preset values
from “30 Min.” to “180 Min.”).
switch on or off automatically at the time you
select.
timer automatically turns on the TV.
timer automatically turns on the TV.
When you set the timer “On”, the TV will
eventually turn off, if no controls are operated for
3 hours after the TV was turned on by timer. This
function is only available in timer “On” mode and
prevents overheating or leakages, which may
occur if a TV is on for too long.
you manually adjust the TV’s
tuner if you have difficulty
tuning channels.
pressing the œ or √ button.
press the MENU button.
pressing the
easy-to-remember label to
any channel (i.e., “CBS”,
“ESPN”, “PBS2”, “CNN1”,
etc.). A label consists of four
fields, where each field is a
letter (A~Z), a number (0~9),
-, or a blank. When the INFO button is pressed, the
channel label will appear next to the channel number.
signal causes an unclear,
noisy picture, the “LNA”
feature improves the picture
quality by setting to “On”. If
you experience noise on a
certain channel, set the
“LNA” to “On” or “Off” for this channel, to obtain the
optimum picture.
Add/Delete
Fine Tune
Name
channels for both “off-air” (antenna) and cable
channels. After the available channels are memorized,
use the CH
This eliminates the need to change channels by
entering the channel digits. There are three steps for
memorizing channels: “Air/Cable”, “Auto Program”
and “Add/Delete”.
memorizing the available
channels, you must
specify the type of signal
source that is connected
to the TV (i.e., an
antenna or a cable
system).
button.
automatically stored in
memory when channels
are selected by the direct
tuning function.
at any time to interrupt
the memorization process.
channel to display the
channels you want only.
To use the Add/Delete
function, first run Auto
Program.
“Added” by pressing the
… or † button.
Add/Delete
Fine Tune
Name
LNA