Manual page

Samsung DVD-VR325 User Manual (ver.1.0)
C
onnections
16 - English
Method 3 : Antenna + DVD Recorder &
VCR + Cable box +TV :
Cable box with a few
scrambled channels
You can record non-scrambled channels by selecting the
channel on the cable box. You cannot record scrambled
channels that require a cable box.
There are several ways to connect your DVD Recorder
& VCR. Select one of the following video connecting
methods that best suits you below.
Method 1 : Connecting to a Video input jack
Method 2 : Connecting to an S-video input jack
Method 3 : Connecting to Component video input
jacks (Y, P
B
, P
R
)
S-Video, Component video and Progressive
Output Modes
• S-Video and Component video output are available
only if your TV supports S-Video input or Component
video input, respectively. If S-Video or Component
video output does not work, check the TV connections
and the TV input selection settings.
• Compared to standard interlaced video, progressive
scan doubles the amount of video lines fed to your TV,
resulting in a more stable, flicker-free, and clear image
than interlaced video. The progressive scan video out-
put jack is used in progressive output mode. This is
only available with TVs that support progressive scan.
• Consumers should note that not all high definition tele-
vision sets are fully compatible with this product and
may cause artifacts to be displayed in the picture. If
you experience 480 progressive scan picture prob-
lems, it is recommended that you switch the connec-
tion to the ‘standard definition’ output. If there are
questions regarding TV set compatibility with this
model, please contact our customer service center at
1-800-SAMSUNG.
Method 1 : Connecting to a video input jack
Connect a video(yellow) cable between the VIDEO OUT
jack (AV OUT) on DVD Recorder & VCR and VIDEO
(yellow) IN jack on the TV(or AV amplifier).
• You will enjoy regular quality images.
• Connect audio cables (white and red) between the
AUDIO L, R OUT Jacks (AV OUT) on the DVD
Recorder & VCR and AUDIO IN jacks on TV (or AV
amplifier).
Step 3: Connecting the
Video Cable
Wall
Cable box
To RF IN
To RF OUT
RF Cable
To ANT INPUT